Equipment
Cable testing and cable diagnostics

Obtaining detailed information about the condition of insulated power distribution cables through VLF (Very Low Frequency) applied voltage testing, as well as Tangent Delta and Partial Discharge tests, enables operators to identify weak points in medium-voltage networks. This allows for the anticipation and correction of failures in a predictive manner, facilitating optimized and predictable maintenance planning. BAUR's cable testing and diagnostic equipment is essential for ensuring the proper functioning of insulated power distribution networks after installation and/or repair, in compliance with the applicable standards for each type of work.

Cable testing and cable diagnostics

Cable fault location

Insulating oil test

VIOLA TD

BAUR viola TD is an device recommended for performing VLF (Very Low Frequency) withstand test and dissipation factor (Tan Delta) test on insulated cables rated up to 20/35 kV.

FRIDA TD

BAUR frida TD is the recommended device for performing VLF (Very Low Frequency) withstand test and dissipation factor (Tan Delta) test on insulated cables rated up to 12/20 kV.

PD-TAD 62

The PD-TaD 62 is a portable Partial Discharge diagnostic system used in conjunction with a VLF source for diagnosing medium-voltage insulated cables.

LIONA

liona is a portable online PD spot tester for measuring and locating Partial Discharges in cables and switchgear during normal mains operation.

PHG 80 PORTABLE

The PHG 80 portable VLF test system is used for cable and cable sheath testing of medium-voltage cables up to 50 kV.

TRANSCABLE

The transcable from BAUR is a modular vehicle equipped with a diagnostic system for cable fault location and cable diagnostics in single-phase or three-phase cables.

Equipment Cable testing and cable diagnostics